Fabricated from one piece stainless steel 304 as a mixer stirrer by Jiffy Mixer Company Incorporated, USA. Fixed to a Proxxon pocket drill Colt 220/E (28490) or any 1/4″ drill chuck and operate to 1200 rpm. A multipurpose pint mixer for clay slip, paints, food sauces, paper making, laboratory, pharmaceutical, silicon rubber, Plaster of Paris and epoxy solutions with minimum air incorporation. Quick and efficient mixing of fast setting alginate into a smooth paste in hands molding and mixing plaster for subsequent casting. Suitable for solvent and water base. Note solvent mixing require sparkless motor or and air motor drive for safety purposes.
Mixer must be fully immerse in solution at least 1″ from bottom of container before turning on power drill. While running move around the base and upwards and down the container without lifting mixer out of the solution. Non rust stainless steel impellar suited for small batch soap mixing and faster sponification and quickly homogenous the mixture into a smooth solution.
Clean mixer after use with water or solvent with the mixer removed from the power unit. In food use the stainless steel mixer can be placed inside a dish washer.
The LM model is designed for smaller jobs in pint sized containers for a max speed of 1200 RPMS. Tools with 450-750 RPMS. get the best rate of thorough mixing. Mixers can be permanently installed if desired.
It is designed to quickly and thoroughly mix dense and viscous substances in an open container. It eliminates waste and unwanted aeration of materials in addition to cutting mixing time up to 90%. It is equally effective with liquids, dry materials, liquid and dry materials combined, or multiple component materials. Made of stainless steel 304, its patented construction and design is for mixing, not just stirring.
It’s various sizes fit standard 1/4″, 3/8″, 1/2″, 3/4″ chucked power tools. It has two sets of specially welded blades. The vertical ones keep the mixing action between them, the horizontal ones employ an exclusive hydraulic-glow principle that prevents sucking air. In addition, the horizontal blades pull the high density material up from the bottom while forcing the low viscosity solvents down from the top. The leading edge of the lower horizontal blade will scrape the bottom of the mixing container to bring all settled material particles into the mixing unit.
No Splashing-Submerge mixer into materials to be mixed before starting motor; shut motor off before allowing mixing unit to reach surface of the mixed materials.
Will not draw in air -The exclusive hydraulic-flow action of the horizontal blades force just the materials from the upper and lower areas of the container into the mixer.
Thorough Mixing-The two vertical blades keep the main mixing action inside the unit, thus increasing the efficiency of the horizontal blades by exerting pressure on the materials being mixed.
Fast Mixing – Cuts time up to 90%- A 5 gallon can of separated paint can be thoroughly mixed and blended in about 60 seconds.
Special Weld Construction-Made entirely of rugged stainless steel 304, all stress joints are specially welded for extra strength so it is virtually impossible for them to break even when mixing extremely heavy materials such as slurry and mud.
Puncture-Proof/Safe Operation-The exclusive patented protective ring design prevents puncture or damage to the walls of the mixing containers. It also prevents the breaking or bending of the horizontal blades. In addition, the ring eliminates accidents should the mixer be accidentally started outside of a container.
Quick, Easy, Cleanup-Just rotate mixer in appropriate thinner or solvent.
MADE OF STAINLESS STEEL 304
Sample Picture (Proxxon machine is not included)
